Note2:
Please prepare latest firmware updating disc.
* Main Firm is being recorded in HDD, but new HDD has no data.
Writing Procedure of Main Firm:
<<Caution>>
(1) Writing of Main Firm needs 3, 4 minutes.
(2) Never cut the power of DVD Recorder until writing in Firmware ends.
(3) Initial settings and contents of reservation will not change if writing is normally completed.
1. Prepare updating disc for firm ware.
2. Replace HDD.
3. Turn on power of DVD Recorder.
4. After [PLEASE WAIT] is displayed on FL., [HDD ERR] is displayed
on FL.
5. Tray opens automatically.
6. Insert updating disc for Firmware and press OPEN/CLOSE key. (If
a wrong disc was inserted, [NG DISK] [NO FVU] is displayed on
FL.)
7. [LOAD] [LD FVU] [M_FIRM] are displayed on FL alternately.
8. [MAIN] [UPD OK] blink alternately and Tray opens. Take out
disc (Writing was finished).
9. Press Power button to turn off power.
10. Press Power button to turn on power.
11. [HELLO] [SELF CHECK] are displayed on FL.
12. [UNFORMAT] is displayed on FL.
71
To Next Page
Loading...
