FUNCTIONS
AV2 Input
RGB / Video
Ext Link 1
Ext Link
Ext Link 2
Ext Link
Ext Link 2
ENTER
RETURN
SELECT
49
Setup
Tuning
Disc
Picture
Sound
Display
Connection
Others
AV2 Settings
Setting for external units (EXT LINK)
You control the recording function via an external unit (e.g. a receiver) with EXT
LINK. Connect the unit to the AV2 terminal with a 21-pin Scart cable.
Ext Link 1: For digital receivers that send a special recording control signal, e.g.
the F.U.N. receiver (TU-DSF41).
Ext Link 2: External recording control for satellite or digital receivers (video signal).
The Ext Link 2 setting cannot be used if the input signal is in NTSC format.
!
Press FUNCTIONS, select [To Others] with and press ENTER.
!
Select [Setup] with and press ENTER.
!
Select [Connection] with and [AV2 Settings] with , and press ENTER.
!
Select [Ext Link] with and confirm with ENTER.
!
Select [Ext Link 1] or [Ext Link 2] with and confirm with ENTER.
Timer Recording via external units
The beginning of the recording may not be recorded correctly.
The programming for a Timer Recording takes place on an external unit.
Read the operating instructions for your external unit.
Recording programming on an external unit
Switching the DVD Recorder to recording standby mode
The recording begins if an appropriate signal is received from a connected unit.
As long as a video picture is transmitted by the external unit, the selected drive
will record it.
!
Select the recording drive DVD or HDD with DRIVE SELECT.
!
Press EXT LINK. Recording standby mode for EXT LINK controlled recordings
is activated. The selected drive and EXT-L appear on the display.
!
Press EXT LINK to switch off recording standby mode.
EXT-L disappears from the display.
!
Stop the transfer of the recording signal on the external unit.
Switching off recording standby mode
Prematurely cancelling recording
!
Press EXT LINK to switch off recording standby mode.
EXT-L disappears from the display.
To Next Page
Loading...
