Getting started
VQT3F57
10
Basic Connection
3D programmes can be played back when this unit is connected to a 3D compatible TV using a High
Speed HDMI cable.
≥Before connection, turn off all equipment and read the appropriate operating instructions.
≥Other amplifier connections (> 84)
≥When using Communication Camera (> 61)
BE SURE TO READ THE CAUTION FOR AC MAINS LEAD ON PAGE 5
Required setting:
Set “HDMI Audio Output” to “On” (> 75).
(The default setting is “On”.)
After completing the connections, proceed to Easy Setting (> 13).
≥ Keep the RF coaxial cables as far away as possible from other cables.
≥ Do not roll up the RF coaxial cables.
HDMI
RF IN
HDMI
AV OUT
RF IN
RF OUT
AC IN
HDMI cable
Aerial cable
RF Coaxial cable (supplied)
AC mains lead (supplied)
TV’s rear panel
This unit’s rear panel
To household mains socket
(AC 220 to 240 V, 50 Hz)
Connect only after
all other
connections are
complete.
To the aerial
DMR-HW100EB-VQT3F57_eng.book 10 ページ ２０１１年８月５日 金曜日 午後２時４分
To Next Page
Loading...
