Panasonic DVD-CV50

Basic Operations a
„arr
mnn
-nsc SKIP
2 |
i
| OPEN/CLOSE |
j
E
| l
i
3 | Label must face
ae rer ASJ. upward. (With double- |
sided discs, load
so the label for the |
side you want to play
is facing up.)
3" (8 cm) disc
5” (12 cm) disc
OPEN/CLOSE
| Basic play |
Preparations
eEnsure connections to your television and audio equipment are
correct. :
e Turn on your television and other equipment.
e Switch the video input mode on the television to suit the type of
connection you have made (e.g., VCR 2).
{1 Press [POWER (/I] to switch on the
power.
2 Press [4 OPEN/CLOSE] to open the
drawer.
3 Place the disc(s) on the disc tray(s).
eè Insert inside the guides. i
e Do not load more than one disc in each tray.
e You can load discs two at a time by pressing [DISC SKIP] to
rotate the carousel.
Caution:
Do not touch the drawer or carousel while they are in
motion, and do not attempt to rotate the carouse! by
hand; doing so could result in incorrect operation of the
unit and/or,.damage to the discs.
4 Press [4 OPEN/CLOSE] to close the
drawer.
After closing the drawer, the DISC 1-5 indicators may light up
even if there is no disc in the disc tray. This will depend on the
disc tray position. The indicator will go out when an empty tray
is in the play position.
Do not close the drawer by hand.
5 To start play from the disc in the play position,
Press [P].
or
To start play from a specific disc,
Press [DISC 1-5] to select the disc
number.
Example: To select disc 1, press [DISC 1].
Play begins.
E Sequential modes (1 or 2)
All the discs loaded in the disc trays will be played according to the
sequential mode (1 or 2) currently selected.
For details on the sequential modes, see page 15.
Pressing [DISC SKIP] may be necessary to proceed to the next disc
after play of DVDs and Video CDs with playback control.
E DISC 1-5 indicators
After the unit reads a disc, the DISC 1—5 indicators are as follows:
No light: No disc
Orange: DVD
The indicator remains green in other cases.