Panasonic DVD-CV50

c Connecting audio equipment with 2-channel audio input terminals
You can enjoy stereo sound if you connect an amplifier or system component that has 2-channe! audio input terminals.
Amplifier and.speakers or system component
Read the instructions for the amplifier and speakers or
system component for connection details.
Dolby Pro Logic amplifiers
elf you connect a Dolby Pro Logic amplifier, you will
also need to connect center and surround speakers to
enjoy surround sound. Read the instructions for the
equipment for connection details.
Turn V.S.S. off ( page 26). Dolby Pro Logic will not
function correctly if V.S.S. is on. i
When you have finished connection
eGo to “7 Digital Audio Output” and set “1 PCM Down Conversion” to
“No” ( page 40).
etn “8 Speaker Setting”, select “2 2-channel” (= page 42).
Align the plug with
the terminal
e Remove the dust protection cap from the optical digital audio
output terminal and connect the cable firmly so that the
configurations of both the cable and the terminal match.
Keep the dust protection cap and reattach when not using the
terminal. ‘
Optical digital audio cable
eDo not bend the optical digital audio cable when connecting it.
System component or amplifier with digital audio input
terminals and speakers
e Read the instructions for the amplifier and speakers or system:
component for connection details.
When you have finished connection
Make changes to “7 Digital Audio Output” as shown ( page 40).
POM Down Conversion
DTS Digital Surround
% If this is set to “No”, no audio will be output when DVDs recorded in
96 kHz linear PCM are played. (Audio will be output as it is if the
DVD does not have copyright protection recorded on it.)
These changes to digital audio. output must be made, other-
wise signals the equipment cannot handle, bitstream, will be
output. If the signals are output as bitstream, “noise” will be
output which can cause harm to your ears and speakers.
èin “8 Speaker Setting”, select “2 2-channet” (= page 42).
The sound for speakers other than the front left and right speakers
will not be heard if you do not select “2 2-channel”.
Home Theater le |