Panasonic DVD-CV50

|
Connection
to
a
television
|
eEnsure that this unit and other equipment to be connected are switched to the standby mode or off and disconnect the AC power supply cord
before commencing connection.
@Do not block ventilation holes of any of the equipment and arrange thems so that air can circulate freely.
e Read through the instructions before connecting other equipment.
e Ensure that you observe the color coding when connecting audio and video cables.
See page 36 for information about how to upgrade your system with other audio/visual equipment.
ə Peripheral equipment and optional cables sold separately unless otherwise indicated.
eTV volume may be lower when playing DVDs than during television broadcasts. Turn the volume up while playing DVDs and reduce it to the
previous level before switching the source back to television to avoid sudden changes in volume.
When you have finished connection, select the appropriate screen type at the initial setting “6 TV Aspect” according to your television (4:3/16:9)
{= page 11). No changes are needed if you connect the unit to a conventional television (4:3).
Conserving power
e The unit consumes approximately 2.0 W even when it is turned off with [POWER (/I]. To save power when the unit is not to be used for a long
time, unplug it from the household AC outlet.
Getting Started a
Connect Your Unit Directly To Your Do not place the
Television. unit on amplifiers or
{f the unit is connected to the television through a video cassette other equipment
recorder, the picture may not be played correctly due to the .
copy guard. So we strongly recommend you do not connect the which may become
unit to your video cassette recorder when setting up your home hot.
entertainment system. The heat can damage the unit.
Connect to the television section if you connect the unit to a
combined television-video player.
Connecting to a television with video input terminal
AUDIO VIDEO
L © o Q To household
AC outlet
©
| Television
AC 120 V, 60 Hz
AC power supply
cord (included)
Audio/video cable (included)
(See the note at the bottom of this page.)
Back of the unit
elf your television is monaural, use a stereo-monaural audio cable instead of the supplied audio/video cable. The video part of the cable (yellow)
can still be used if required. Aüdio cable
=b To the unit's audio output terminal (white, “L”)
To TV audio input terminal + e n a
=> To the unit's audio output terminal (red, “R”}
ROTS455