Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not
solve the problem:
In the U.S.A., contact the Panasonic Customer Call Center at l-800-21 l-7262, or e-mail consumerprodocts@panasonic.com, or web site
(http://www.panasonicom).
In Canada, contact Panasonic Canada Inc. Customer Care Centre at l-800-561-5505, web site (www.panasonic.ca), or an authorized
Servicentre closest to you.
In other areas, consult your dealer.
Power
Page
The unit is automatically
*To conserve power, the unit automatically switches to standby after approximately 30 minutes in
-
switched to the standby mode.
the stop mode. Turn the power back to ON.
*The unit was switched to standbv bv the SLEEP timer.
I I
8
Operation
No operations can be performed
with the remote control.
*Check the batteries are installed correctly.
*The batteries are depleted: Replace them with new ones.
*Point the remote control at the remote control sensor and operate
Alternative languages fail to be
*In the case of some discs, the alternative language cannot be selected with [AUDIO] or
[SUBTITLE]. Try selectinrl it from the disc’s menu if one is available.
No subtitles.
l
Sub$tles appear only with discs that contain them.
*Subtitles are cleared from the television. Display the subtitles,
1 Angle cannot be changed.
*This function is dependent on software availability. Even if a disc has a number of angles
12
You have forgotten your ratings
password.
Reset all the settings to Factory
Preset.
Sound
*While stopped, press and hold [ 1441 and [I I] on the unit and then also press and hold [C] on
the unit until “Initialized” disappears from the television. Turn the unit off and on again.
All settings will return to the default values.
-
his unit to other equipment through the DIGITAL AUDIO OUT terminal,
ct settings for “Dolby DigItal”, “DTS Digital Surround” and
To Next Page
Loading...
