Panasonic DVD-RV60

33
VQT8626
Home Theater
Home theater
Settings in
“8 Speaker Setting”
Select “1 Multi-channel”
≥Speaker presence
⇒Set speakers you
have connected to
“Yes”
≥Set delay time if
necessary
≥Correct output
balance if necessary
Select “2 2-channel”
Select “2 2-channel”
Select “2 2-channel”
Settings in
“7 Digital Audio
Output”
PCM Down
Conversion⇒“No”
≥PCM Down
Conversion⇒“Yes”
≥Dolby Digital/DTS
Digital Surround/
MPEG
⇒Settings depend on
your decoding
equipment
PCM Down
Conversion⇒“No”
≥PCM Down
Conversion⇒“Yes”
≥Dolby Digital⇒“PCM”
≥DTS Digital Surround
⇒“PCM”
≥MPEG⇒“PCM”
∫ Upgrading your audio equipment
To enjoy the 5.1-
channel surround
sound found on DVDs
using the unit’s built-
in decoder
To enjoy the 5.1-
channel surround
sound found on DVDs
using the decoder in
another unit
To enjoy stereo
through an analogue
amplifier
§2
To enjoy stereo
through a digital
amplifier
§2
Equipment
Amplifier with 5.1-
channel audio input
terminals
Amplifier with built-in
decoder or a separate
decoder-amplifier
combination
§1
Analogue amplifier or
system component with
2-channel audio input
terminals
Audio equipment with
digital audio input
terminals
Speakers
≥Front speakers (L/R)
≥Subwoofer
≥Surround speakers
(L/R)
≥Center speaker
≥Front speakers (L/R)
≥Subwoofer
≥Surround speakers
(L/R)
≥Center speaker
Front speakers (L/R)
Front speakers (L/R)
Page
[A]
34
[B]
35
[C]
36
[D\
36
§1Connect speakers if necessary and make the speaker settings on
the amplifier.
§2If you have connected a Dolby Pro Logic amplifier, you may need
to connect center and surround speakers.
∫ Upgrading your television
≥You can connect CRT projectors, LCD projectors, and projection
televisions.
≥See “Connection to a television” (➡ pages 9 and 10) for details on
connection.
Note
≥The equipment connections described are examples.
≥Additional equipment and cables are not supplied.
Setup chart
Types of
connection
Equipment and
settings
Manufactured under license from Digital Theater Systems,
Inc. “DTS” and “DTS Digital Surround” are trademarks of
Digital Theater Systems, Inc. C 1996 Digital Theater Sys-
tems, Inc. All rights reserved.
Manufactured under license from Dolby Laboratories. “Dolby”,
“Pro Logic” and the double-D symbol are trademarks of Dolby
Laboratories. Confidential unpublished works. C 1992–1997
Dolby Laboratories. All rights reserved.
For your reference
≥Dolby Digital is a digital sound compression technique developed
by Dolby Laboratories.
Supporting 5.1-channel surround sound, as well as stereo (2-
channel) sound, this technique enables a large quantity of sound
data to be efficiently recorded on a disc.
≥DTS Digital Surround is a 5.1-channel surround sound system,
which is widely used in movie theaters around the world. The
separation between channels is good and provides a very real
surround effect.
≥Linear PCM is an uncompressed digital audio signal. While a CD is
recorded in 44.1 kHz/16 bit, a DVD is recorded in 48 kHz/16 bit up
to 96 kHz/24 bit. Therefore, the sound reproduced with these
signals is potentially better than that found on CDs. This player
reproduces linear PCM in two channels.
≥Bitstream is a compressed digital audio signal. This signal can be
decoded into different channels to produce, for instance, 5.1-
channel surround sound.
≥The digital audio output terminal (optical) converts electrical signals
into optical signals and transfers them to an amplifier. These optical
signals are immune to electrical interference, and they also have
minimal effect on other equipment.