Panasonic DVD-RV60

39
VQT8626
Home Theater
2
ENTER
3
ENTER
4
ENTER
5
Speaker Setting
1 Multi-channel
2 2-channel
Press RETURN to exit
1
1 Disc Languages
Level 8
2 Ratings
3 Menu Language
4 On-Screen Messages
5 FL Display
6 TV Aspect
7 Digital Audio Output
8 Speaker Setting
Press RETURN to exit
9 Other Settings
English
Bright
4:3
2-channel
SETUP
ENTER
Press RETURN to exit
Speaker Setting
Exit
Test
0
dB
0
dB
0
dB
0
dB
0
ms
0
ms
LS RS
C
SW
TOP MENU MENU
DISPLAY
PLAY MODE SUBTITLE AUDIO ANGLE
ENTER
RETURN
1 2 3
A-B REPEAT
4 5 6
7 8 9
SETUP CANCEL
0 S 10
REPEAT MODE
V.S.S.
2·3·4·5
1
RETURN
L R
Home theater
Speaker Setting
Here you can change the settings for the built-in decoder.
In general, these changes have no effect if you connect the player to
other equipment through the digital audio output terminal (make the
necessary changes on the other equipment). Multi-channel MPEG 2
audio is an exception (➡ below).
Common procedure
1 Press [SETUP] in the stop mode.
The initial settings screen is displayed.
2 Press the cursor buttons [3, 4] to se-
lect “8 Speaker Setting” and press
[ENTER].
3 Press the cursor buttons [3, 4] to se-
lect the item and press [ENTER].
1 Multi-channel
If you have connected three or more speakers. (Proceed to
step 4)
2 2-channel (Factory preset)
If you have connected 2 speakers. (You will return to the
menu shown in step 1. Settings are not necessary.)
4 Change settings to suit your speakers
and the listening position
(➡ page 40).
≥Setting the size and presence of your speakers
Choose “Yes” for speakers you have connected. Sound will
not be output if you choose “No”.
≥Delay time
Allows you to make up for differences in distance if you
cannot place your speakers in the optimum position. (Dolby
Digital DVD only)
≥Channel balance
Allows you to adjust the output level of the speakers to make
up for differences in volume caused by different types of
speaker or distance.
5 Press the cursor buttons [3, 4,
2 2
2 2
2,
11
11
1] to select “Exit” and press [EN-
TER].
The screen illustrated in step 2 is displayed.
To cancel during setup operation
Press [RETURN]. (The previous screen is displayed.)
To exit the initial settings screen
Press [SETUP] or [RETURN] .
When playing multi-channel MPEG 2 audio
To enjoy the multiple channels on this kind of software, do the
following.
≥Connect the player to an amplifier with the 5.1-channel audio input
terminals (➡ page 34) and select “1 Multi-channel” in step 3.
or
≥Connect to an amplifier that can decode MPEG 2 through the digital
audio output terminal and in “7 Digital Audio Output”, select “2
Bitstream” for “4 MPEG” (➡ page 37).
If any other kind of connection is used, including headphones, be
sure to select “2 2-channel” in step 3.
(Continued on next page)