6 DISPLAY METHOD OF MASSAGE BLOCK TOTAL USE
TIME AND OPERATION TIME
Adjustment of pressure sensor
First, keep the Massage mechanism block unloaded with pressure and move it upward halfway.
If the Massage mechanism block is at the highest or lowest position, you cannot arrange the pressure sensor correctly because
the fabric becomes tense with pressure.
1. While pushing On/off button and the User program button B simultaneously, turn on the power switch and continue to hold the
buttons for approximately 5 seconds. Release after the Focus button lights up.
2. Push the Focus button and automatically it lights off.
Turn off the Power source switch and turn it on again, then the adjustment is finished.
Total use time & Display method
While pushing the Shiatsu button and the Deep button simultaneously, turn on the power switch and continue to hold the
buttons for approximately 5 seconds. Release after the User program button A.
e.g. In the above case, 3000 + 500 + 10 + 5 = 3515 hours.
It is possible to indicate up to 5,995 hours.
If the use time is less than 5 hours, 5 hour unit does not light up. If it is less than 10 hours, one 5 hour unit lights up.
9
EP3203-U1
To Next Page
Loading...
Need help?
General