Panasonic FP7 Series Additional Functions Manual

FP2/FP2SH Program Conversion Function
4-2
4.1 List of Conversion Instructions to FP7
The patterns for converting FP2/FP2SH instructions to FP7 instructions have been changed to
the following contents from the Ver.2.11.0.0 of FPWIN GR7(S).
Some instructions and operand settings cannot be converted to FP7 instructions.
For the operation when an instruction cannot be converted, refer to the following "Operation
when an instruction cannot be converted".
 Operation when an instruction cannot be converted
When specifying an instruction or operand that cannot be converted, the program conversion
to FP7 is not performed, and the result is output to the block comment.
Example) Before converting an FP2SH program
Example) After converting the program to FP7 program
 Basic instructions
FP2/FP2SH instruction
FP7 instruction
Basic
instruction
(Boolean)
Operand condition
Boolean
Name
TM（X/Y/R/L）
When specifying a 16-bit device for the
setting value
(WX/WY/WR/WL/DT/LD)
TM16
（X/Y/R/L）
16-bit timer
(*) When specifying SV/EV device for the
setting value
TMX
（X/Y/R/L）
Timer
(*) When specifying a constant K/H) for the
setting value
CT
When specifying a 16-bit device for the
setting value
(WX/WY/WR/WL/DT/LD)
CT16-
16-bit counter
(*) When specifying SV/EV device for the
setting value
CT
Counter
(*) When specifying a constant K/H) for the
setting value
* : There is no change from the versions before Ver.2.10 of FPWIN GR7(S).

Panasonic FP7 Series Specifications

General

Brand	Panasonic
Model	FP7 Series
Category	Controller
Language	English