- 52 -
This function detects the horizontal tilt of the unit, and automatically corrects it to the level
position before recording.
≥ Select [EXIT] and press the button in the centre or press the MENU button to complete the
settings.
≥ Icon is displayed in A position.
j When the tilt is corrected:
j When the tilt is above the correction range: /
≥ When the tilt exceeds the correction range, move the unit
to the position where is displayed.
≥ The range that this icon can be displayed correctly the slope is about 45 o to the vertical direction.
≥ The image may move while zooming depending on the tilt of this unit.
≥ To record a level image with a tripod, attach this unit by using “Level Gauge” (l 48), and then use
Level Shot Function.
This function allows you to record colour images in very low light situations. (Minimum
required illumination: approx. 1 lx)
≥ Switch to Manual Mode. (l 39)
≥ Select [EXIT] and press the button in the centre or press the MENU button to complete the
settings.
≥ Recorded scene is seen as if frames were missed.
≥ If set in a bright place, the screen may become washed out for a while.
≥ Bright dots that are usually invisible may be seen, but this is not a malfunction.
≥ This function cannot be used when [TIME LAPSE REC] is used.
≥ Using a tripod is recommended.
≥ In darker areas, Auto Focus may focus a bit slower. This is normal.
[LEVEL SHOT]
: When this function is set to on.
: When this function is set to off.
: [CAMERA SETUP] # [LEVEL SHOT] # [ON]
[COLOUR NIGHT VIEW]
: [CAMERA SETUP] # [COLOUR NIGHT VIEW] # [ON]
MENU
To Next Page
Loading...
