Panasonic HC-MDH2 - Connecting to a PC (File transfer;nonlinear editing)

- 96 -
When this device and a computer for editing are connected using a USB Connection Cable, image
data in the SD card and built-in memory can be transferred.
≥ Concerning non-linear editing, refer to the instruction manual of your editing software.
≥ It is impossible to write data to the SD card and built-in memory on this unit from a PC
Operating environment (mass storage)
∫ If using Windows
≥ Even if the system requirements mentioned in these operating instructions are fulfilled, some PCs
cannot be used.
≥ Operation is not guaranteed in the following cases.
j When 2 or more USB devices are connected to a PC, or when devices are connected through
USB hubs or by using extension cables.
j Operation on an upgraded OS.
j Operation on an OS other than the one pre-installed.
≥ This software is not compatible with Microsoft Windows 3.1, Windows 95, Windows 98,
Windows 98SE, Windows Me, Windows NT and Windows 2000.
≥ This software is not guaranteed on Microsoft Windows XP.
≥ The USB equipment operates with the driver installed as standard in the OS.
With a PC
Connecting to a PC
(File transfer/nonlinear editing)
PC IBM PC/AT compatible PC
OS Windows 8 (32 bit/64 bit)
Windows 7 (32 bit/64 bit) or
SP 1
Windows Vista
(32 bit) (SP2)
CPU 1 GHz or higher
32-bit (x86) or 64-bit (x64) processor (including compatible CPU)
RAM Windows 8/Windows 7: 1 GB or more (32 bit)/2 GB or more (64 bit)
Windows Vista Home Basic: 512 MB or more
Windows Vista Home Premium/Business/Ultimate/Enterprise:
1GB or more
Interface USB port
Other
requirements
Mouse or equivalent pointing device