Panasonic HC-V787 - Connecting to a Wireless Access Point

- 144 -
When [Wi-Fi] is selected
≥ If you are using an Android device, start up the smartphone application “Image App”.
1
(If the device is Android)
On the smartphone, select [Wi-Fi], and select the SSID displayed on this unit.
(If the device is iOS)
On the smartphone, select the SSID displayed on this unit from the Wi-Fi
setup menu.
2
(If the device is Android)
Enter the Password displayed on this unit.
(If the device is iOS)
After entering the Password displayed on this unit, start up the “Image App”.
3 Follow the on-screen instructions of the smartphone to set up a connection.
≥ When the settings is complete, the smartphone and this unit are connected directly, allowing you
to use remote operations. (l 132)
Connecting to a wireless access point
Check if the wireless access point you are using is compatible with WPS
j If the wireless access point is compatible with WPS:
Proceed to the following [Easy Connection (WPS)]
j If the wireless access point is not compatible with WPS:
“Searching for wireless access points to set up a connection” (l 145)
1 Press Wi-Fi button on this unit.
2 Touch [Wi-Fi Setup].
3 Touch [Set Wireless Access Point].
4 Touch the part with no display of a wireless
access point.
≥ For information on how to delete wireless access points or
change the search order of wireless access points, please
refer to [Set Wireless Access Point] on page 152.
5 Touch [Easy Connection (WPS)].
6 Set the wireless access point to waiting for WPS.
≥ For further details, please read the operating instructions for the
wireless access point. (When using a tethering connection, please
read the operating instructions for the smartphone.)
≥ A message is displayed when the connection is complete. Touch
[EXIT], and exit [Set Wireless Access Point].
≥ A message is displayed when the connection attempt fails. Touch
[EXIT], and set the connection again.
[Easy Connection (WPS)]


A [Delete]
B [EXIT]