Panasonic HC-V787 - Page 160

- 160 -
∫ Scanning a QR code to set up a connection
1 (When using the Wi-Fi Setup menu)
Press Wi-Fi button on this unit and touch [TWIN
CAMERA].
(When using the recording screen)
Touch the recording screen on this unit and
touch .
2 Touch [Smartphone] on the screen of this
unit.
3 Touch [QR code] on the screen of this unit.
4 Start up the smartphone application
“Image App”.
5 On the smartphone, select [QR code] to scan the QR code displayed on the
screen of this unit.
≥ When using an iOS device, perform the following operations:
1 Select the option that allows you to install the app on the profile screen of the “Image App”, and
follow the on-screen instructions to complete the installation.
2 Press the home button to close the displayed screen.
3 Touch [NEXT] on the screen of this unit to display its SSID.
4 After selecting the network name (SSID) of this unit from the Wi-Fi setup of the smartphone,
start up “Image App”.
≥ When the connection is complete, the image being captured by the smartphone will be displayed
on the Sub Window of this unit.
≥ If the QR code cannot be scanned, refer to “Selecting this unit’s SSID and entering a password
on the smartphone to set up a connection”. (l 158)
1/2


A [TWIN CAMERA]
B [EXIT]
 


A [Wireless Twin Camera]
B [Smartphone]
C [Other Camera]
D [CANCEL]