- 215 -
9 (When selecting [WEP]/[TKIP]/[AES])
Touch [INPUT], then enter the Password.
≥ For details on how to enter characters, refer to page 137.
≥ When the entry is complete, touch [Enter].
≥ A message is displayed when the connection is complete. Touch [EXIT], and exit [Set Wireless
Access Point].
≥ Check the wireless access points instruction manual and settings when a saving wireless access
point.
≥ The Encryption methods are [AES], [TKIP] and [WEP] in descending order of strength.
We recommend you connect with the strongest possible Encryption method.
≥ When the signal of the wireless access point is weak, a connection may not be established.
Refer to “Messages” (l 265) and “Troubleshooting” (l 267) for details.
≥ Transmission speed may decrease, or may not be usable depending on the environment it is
used in.
Setting up a direct connection to a smartphone
Check the [Direct Connection Password] setting in [Wi-Fi Setup]. (l 221)
≥ The default setting is [OFF].
Select [ON] as needed, for example when the setting seems necessary for your Wi-Fi
environment.
≥ When [Direct Connection Password] is set to [OFF]
j Proceed to the following section, “When [Direct Connection Password] is set to [OFF]” in
“Using [Remote Ctrl] with a direct connection”. (l 184)
≥ When [Direct Connection Password] is set to [ON]
If your smartphone is compatible with WPS, refer to “[Easy Connection (WPS)]”. If not, refer to
“Connecting with QR code”.
j Proceed to the following [Easy Connection (WPS)] (l 216)
j Proceed to the “Connecting with QR code” (l 216)
j Proceed to the “Connecting by entering an SSID and Password” (l 217)
When the Wi-Fi connection is complete, refer to “When [Direct Connection Password] is set to [ON]”
in “Using [Remote Ctrl] with a direct connection”. (l 185)
Confirming that the Wi-Fi connection is complete
j The status indicator of this unit is lit green
j is displayed on the screen
HC-WXF1-VXF1-VX1-V800EBEP-DVQP1585_eng.book 215 ページ ２０１８年２月２３日 金曜日 午前９時９分
To Next Page
Loading...
