To Next PageTo Next PageWhy is my Panasonic HC-WX970 Camcorder not detected when connected via USB?
If your Panasonic Camcorder isn't detecting the connected device via USB cable, and you're using only battery power, try reconnecting with the AC adapter plugged in.
Why does my Panasonic HC-WX970 battery run down so quickly?
There are a few reasons why your Panasonic Camcorder battery might be draining quickly. Ensure the battery is fully charged. Keep in mind that in cold environments, battery life is reduced. Also, batteries have a limited lifespan, so if it still drains quickly after a full charge, it may need replacing.
Why is the remaining battery indication not displayed properly on my Panasonic HC-WX970 Camcorder?
The remaining battery capacity indication on your Panasonic Camcorder is an approximation. If it's not displaying correctly, fully charge the battery, discharge it completely, and then charge it again.
I have forgotten the password for the Wi-Fi on my Panasonic HC-WX970, what to do?
If you have forgotten the Wi-Fi password for your Panasonic Camcorder, perform [Reset Wi-Fi Settings] from the Setup menu. This will restore the Wi-Fi settings to their original state at the time of purchase, allowing you to reconfigure the Wi-Fi settings. Note that this will delete all Wi-Fi settings, including the “LUMIX CLUB” Login ID and registered wireless access points.
Why does my Panasonic Camcorder battery run down quickly?
If your Panasonic Camcorder battery drains fast, ensure it is fully charged. In cold environments, battery life decreases. Batteries have a limited lifespan; if the operating time remains short after a full charge, the battery is likely worn and requires replacement.
What to do if my Panasonic HC-WX970 Camcorder displays 'ERROR OCCURRED'?
If your Panasonic Camcorder displays the error message, it has detected an error. Restart the unit by turning it off, and then on again. If the unit is not turned off and on, it will be turned off in about 1 minute. If the error persists after restarting, repair is needed. Detach the power connected, and consult the dealer who you purchased this unit from. Do not attempt to repair the unit by yourself.
What to do if my Panasonic HC-WX970 won't operate even when turned on?
If your Panasonic Camcorder is on but not operating, remove the battery or AC adapter, wait about a minute, and reconnect it. Wait another minute, then turn the unit on again. Note that doing this while the media is being accessed may damage the data on the media. If normal operation isn't restored, detach the power connected, and consult the dealer who you purchased this unit from.
Why does the color or brightness change on my Panasonic HC-WX970, or why do I see horizontal bars?
Color or brightness changes and horizontal bars may appear when recording under fluorescent, mercury, or sodium light. This isn't a malfunction. In Motion Picture Recording Mode, use Intelligent Auto Mode/Intelligent Auto Plus Mode, or set the shutter speed to 1/100 in 50 Hz areas, or 1/125 in 60 Hz areas. This will not affect the recorded image in Still Picture Recording Mode. In FULL HD Slow Motion Mode, setting the shutter speed to 1/100 seconds reduces the intensity of the problem.
What to do if an error message appears on PC when the USB cable is disconnected from my Panasonic HC-WX970?
To safely disconnect the USB cable from your Panasonic Camcorder, double-click the icon located in the task tray and then follow the on-screen instructions.
What if my Panasonic Camcorder does not recognise the SD card?
If the SD card inserted in your Panasonic Camcorder is not recognized, format the SD card using the camcorder itself. If an SD card is formatted on a PC, it might not be recognized by the unit.
General| Sensor Type | MOS |
|---|---|
| Sensor Size | 1/2.3 inch |
| Optical Zoom | 20x |
| Digital Zoom | 50x |
| Focal Length | 4.08 - 81.6 mm |
| LCD Screen Resolution | 460, 800 dots |
| Touchscreen | Yes |
| Microphone Input | Yes |
| Headphone Jack | Yes |
| Wi-Fi | Yes |
| NFC | Yes |
| Battery Type | Lithium-ion |
| Video Resolution | 3840 x 2160 |
| Stabilization | Hybrid Optical Image Stabilizer |
| Display | 3.0" LCD |
| Viewfinder | Yes |
| Recording Format | AVCHD / MP4 |
| Frame Rate | 60p / 30p |
| Audio Recording | Dolby Digital |
| USB | USB 2.0 |
| HDMI | Yes |
| Effective Pixels | 6.03 MP |
