117
VQT2M51
With a PC
Setup
2
Connecting to a PC
≥ Connect this unit to the PC after the software applications are installed.
≥ Remove the supplied CD-ROM from your PC.
A USB cable (supplied)
1 Connect this unit to the AC adaptor.
≥ It is possible to use the unit connected to the PC with the batteries only, but you will not be
able to write data into the unit.
≥ Connect with the AC adaptor when using the Conversion Assist Function.
2 Turn on the unit.
≥ This function is available in all modes.
3 Connect this unit to a PC.
≥ Do not use any other USB cables except the supplied one. (Operation is not guaranteed
with any other USB cables.)
≥ When using the battery, the LCD monitor turns off after about 5 seconds. Touch the screen
to turn the LCD monitor on.
≥ The Smart wizard screen is automatically displayed when HD Writer AE 2.0 is installed.
≥ This unit is automatically recognized as an external drive of the PC. (l 119)
≥ When HD Writer AE 2.0 is not installed, a USB function selection screen will appear. Touch
[PC]. When you select an option other than [PC], reconnect the USB cable.
≥ When using an SDXC Memory Card, check the following support site.
http://panasonic.net/avc/sdcard/information/SDXC.html
HDCSD60_TM60_HS60-P_PC-VQT2M51_eng.book 117 ページ ２０１０年１月１８日 月曜日 午前１１時３３分
To Next Page
Loading...
