22
VQT2M51
≥ Press the power button to turn off the power. (l 28)
Install the battery by inserting it in the direction shown in the figure.
Inserting/removing the battery
Removing the battery
Be sure to hold down the power button until
the status indicator goes off. Then remove
the battery while supporting the unit to
prevent it from dropping.
Move the battery release lever in the
direction indicated by the arrow and
remove the battery when unlocked.
A Insert the battery until it clicks
and locks.
CAUTION
Danger of explosion if battery is
incorrectly replaced. Replace only with
the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to
the manufacturer’s instructions.
HDCSD60_TM60_HS60-P_PC-VQT2M51_eng.book 22 ページ ２０１０年１月１８日 月曜日 午前１１時３３分
To Next Page
Loading...
