2.2.1 About LED
The status of the scanner is displayed by the LED (Red) ( ) and the LED (Green) ( ), as shown in the
table below:
LED (Red) LED (Green)
Status
OFF OFF Power OFF
*1
OFF Blinking (Fast) Warming up
OFF ON Ready mode or Scanning
Blinking (Slow) ON Notification mode
OFF Blinking (Slow) Sleep mode
*2
or Cleaning mode
Blinking (Slow) Blinking (Slow) Sleep mode
*2
and Notification mode
ON OFF Error
*3
OFF Blinking (Fast, 2 times consecutively) Double feed skip mode
OFF Blinking (Fast, 3 times consecutively) Dog-ear Detection Skip mode
*1
If the power of
f feature in sleep mode is enabled, and if no operation is performed for a certain period of time, the scanner will be
turned off automatically. Press the power button of the scanner to turn it on. You can enable/disable the power off feature, and
change the time until the scanner turns off in User Utility.
*2
If no operation is performed for 15 minutes or longer, the scanner will enter sleep mode automatically to conserve energy. Press
any button (except the power button) on the scanner’s operation panel to return to ready mode. The time until the scanner enters
sleep mode can be changed in User Utility.
*3
For details about the error, refer to "8.2 Error Messages" (page 68) or check in User Utility.
2.2.1 About LED
14
To Next Page
Loading...
