3. Clean the conveyor
, sensors, rollers, and scanning glasses.
• Clean the parts in the following order: conveyor and scanning glasses, sensors, rollers.
• For details about cleaning, refer to the following:
– "6.2.1 Cleaning the Conveyor and Scanning Glasses" (page 46)
– "6.2.2 Cleaning the Sensors" (page 47)
– "6.2.3 Cleaning the Rollers" (page 48)
4. Close the ADF door.
• After cleaning, push both sides of the ADF door down slowly until it clicks into place.
Note
• If roller cleaning notifications via the After Clean Roller Counter are enabled, reset the After Clean
Roller Counter in User Utility to 0 after turning ON the unit’
s power. For details, refer to the User Utility
help.
6.2 Cleaning the Inside of the Scanner
45
To Next Page
Loading...
