Panasonic KV-S4085CL - About Status Indicators

About Status Indicators
The status
of the scanner is displayed by the ready indicator (
1
) and the error indicator (
2
), as shown in the
table below:
1
2
1
Ready indicator ( )
(Green)
2
Error indicator ( )
(Red)
Status
ON OFF Ready
ON Blinking (Slow, Long ON)
*1
Caution
*4
OFF ON Error
*4
Blinking (Slow, Long ON)
*1
OFF Sleep
Blinking (Slow, Short ON)
*2
OFF Standby
*5
Blinking (Fast)
*3
OFF Warming up
*1
On for 2 seconds and off for 2 seconds.
*2
On for 1 second and off for 3 seconds.
*3
On for 0.5 seconds and off for 0.5 seconds.
*4
Check the status of the scanner using User Utility. For details about User Utility, refer to the User Utility Reference Manual.
*5
The scanner will enter Standby mode when no operation is performed for 30 minutes, to save power.
To use the scanner again, restart it by pressing any one of the buttons for more than 1 second. The time period before the scanner
enters Standby mode can be configured in User Utility.
(The default setting varies depending on the country/area.)
18 Operating Manual
Location of Controls