Paper Feed Settings
Notice
Before scanning a document, set the hopper position, the paper thickness mode, and the exit direction.
Changing the Hopper Position
When scanning begins, the hopper’s height is adjusted according to the amount of paper, so that the hopper
is at the same level as the feeder. Setting the hopper position beforehand will shorten the scanning time.
Press the hopper key ([ ] or [ ]) to change the hopper position.
The hopper can be moved to the following three heights:
Hopper position Loadable number of sheets
High 100 sheets
Middle 200 sheets
Low 300 sheets
• These guidelines are for using fresh, 64 g/m² (17 lbs.) paper.
Operating Manual 23
Operation
To Next Page
Loading...
