108
Hopper Drive 1. Click “Hopper Drive” on the main menu.
2. Click “START” on the “Hopper Drive” dialog box to start to
execute the open/close operation of the gate until clicking
“STOP”.
3. Click “Close” to return to the main menu.
—
Feed 1. Set documents on the Hopper.
2. Click “Feed” on the main menu.
3. Set “Test Mode” and “Test Condition” depending on each
scanning condition.
Note:
Operation “Imprinter” is available only when the
optional Imprinter is installed.
4. Click “START” on the “Feed” dialog box to start feeding
documents.
5. Click “STOP” on the “Feed” dialog box to stop the test.
6. Click “Close” to return to the main menu.
— Mechanical Deskew is sup-
ported for S5076H only.
LCD Test 1. Click “LCD” on the main menu.
2. Click “START” on “LCD” dialog box to start LCD Test con
tinuously until clicking “STOP”.
3. Click “Close” to return to the main menu.
LCD pattern changes after
clicking "START" on “LCD”
dialog box.
Sleep Mode 1. Click “Sleep Mode” on the main menu.
2. Click “START” on the “Sleep Mode” dialog box to enter the
sleep mode.
3. Click “STOP” to return from the sleep mode.
4. Click “Close” to return to the main menu.
—
Item Operation Default Remarks
To Next Page
Loading...
