Panasonic KV-S5076H - 9 Service Utility & Self Test; List of Functions for Service Utility

98
9.2. List of Functions for Service Utility
Service Utility item list is as follows.
Note:
When two or more scanners are connected to a PC, execute “Select Scanner” to specify the scanner before evaluating.
The procedure is as follows.
1. Click “Select Scanner” on the main menu.
2. Select the product number of the scanner to evaluate.
Item Purpose Remarks
Scanner Status
*2
Used to indicate scanner status (Ready, Error, or Caution) 2
Scanner Information
*2
Used to indicate scanner information such as Model, firmware
version, board revision, memory size, interface, Interface
condition, etc.
2
Scanner Counter
Update Counters
*2
Used to update the values of System Counter. 1, 6
Scanner Condition
Sleep Mode
*2
Used to set “Waiting Time” before entering the Sleep Mode 1
Clean Imprinter
*1 *2
Used to clean the ink jet head of the imprinter 6
Buzzer Setting
*2
Used to set the Buzzer ON/OFF condition 1
User Shading
*2
Used to execute shading correction at the user side, or to restore
the shading data to the default (Factory-setting)
4
Roller Maintenance
*2
Used to set the number of the document scanning that enables
the Service Utility to inform the caution information (roller
replacement timing and roller cleaning timing)
1, 3
Set Default Used to set “Sleep Mode”, “Caution Setting”, and
“Feed Speed” to the default
3
Test 1 LED Used to periodically light the indicators on the front cover 5
Key / Sensor Used to do keys' or sensors' ON/OFF test 5
Feed Motor Used to check the operation of the motor periodically rotating in
the paper-feed direction and its reverse direction
Note:
• Rotating in the paper-feed direction will allow the Paper
Feed Roller Module to go down to perform the paper-feed
function.
• Rotating in the reverse direction will allow the Paper Feed
Roller Module to rise to perform the paper-separation
function.
5
Conveyor Motor Used to check Conveyor Motor rotation 5
DFP Pressure Drive Used to check DFP Pressure Motor rotation 5
Hopper Drive Used to check the operation of the Hopper Motor Operation
Feed Used to check paper feed condition 5
LCD Test Used to check the LCD (S5076H only)
Sleep Mode Used to check whether the sleep mode function works properly 5
CIS LED Level This Item is not used.
CIS Level This Item is not used. 5
CIS Black Level This Item is not used.
Focus Used to check whether CIS operates normally by outputting the
CIS's output level or whether a dust is attached on the Scanning
Glass
5
Double Feed Used to check the level of the Double Feed Detector (R)
(Response level) after setting the ultrasonic emission level of the
Double Feed Detector (G)
5
Memory Used to execute memory R/W test 5
Ionizer Used to check whether ON/OFF (Enable/Disable) control to
output Ionizer properly operates.
5
Test 2 Deskew Assist Motor Used to check Deskew Assist Motor rotation (S5076H only)
Exit Motor Used to check Deskew Assist Motor rotation (S5076H only)
Platen Motor Used to check Platen Motor rotation