1. Prepare the following cleaning supplies.
• Soft and dry cloth
Used to clean the conveyor.
• Thin cotton swab
Used to clean the ion outlets and sensors.
• Roller cleaning paper (KV-SS03)
Used to clean the rollers, scanning backgrounds, and scanning glasses.
Use of the roller cleaning paper is recommended. If you do not have the roller cleaning paper, use a
soft cloth with a small amount of isopropyl alcohol or water.
Do not use commercially available cleaners, detergent, thinner, or benzine. (Doing so may cause
deformation, discoloration or damage.)
2. Press and hold the power button for one second or more to turn off the unit’s power.
3. Push the ADF door release (A ) upwards, and open the ADF door (B ).
(A)(B)
4. Clean the conveyor, sensors, rollers, scanning backgrounds, and scanning glasses.
• Clean the parts in the following order: conveyor, ion outlets and sensors, rollers, scanning backgrounds,
scanning glasses.
• For details about cleaning, refer to the following:
– "Cleaning the Conveyor" (page 3)
– "Cleaning the Ion Outlets and Sensors" (page 3)
– "Cleaning the Rollers" (page 4)
– "Cleaning the Scanning Backgrounds" (page 4)
– "Cleaning the Scanning Glasses" (page 4)
To Next Page
Loading...
