Panasonic KV-S5076H - Page 117

117
Note:
*8
For LED and indicators’ position shown in the above figure, see Sec. 3.
7.
*9
Lamp Test
1 While pushing the “START/STOP Key” on the Control
Panel, turn on the scanner.
——
*9: Every time you
push the
“START/STOP”
Key, the lamp
status will change
periodically, as
follows.
Lamp (F) ON
Lamp (B) OFF

Lamp (F) OFF
Lamp (B) ON

Lamp (F) ON
Lamp (B) ON

Lamp (F) OFF
Lamp (B) OFF

Lamp (F) ON
Lamp (B) OFF

2 Release the key after LED (Back) status changes to
blinking.
OFF 
Blinking
3
Push the “START/STOP Key” once to enter the test
selection mode.
Blinking 
Count
4 Push the “START/STOP Key” once at the timing when
LED (Back) status is 7 (h)
*7
.
5 Push the “START/STOP Key” once to turn on the CCD
Lamp (F).
6 Push the “START/STOP Key” once to turn off the CCD
Lamp (F) and to turn on the CCD Lamp (B).
7 Push the “START/STOP Key” once to turn on the CCD
Lamp (F) and CCD Lamp (B).
8 Push the “START/STOP Key” once to turn off the CCD
Lamp (F) and CCD Lamp (B).
9 Turn off the scanner to finish this test. — —