61
4. Release the 2 poly-sliders that hold the Reference Plate (B) on
both sides.
5. Remove the Gear and poly-slider.
6. Slide and remove the plate.
Reassembling Note: How to attach the spring
1. With one side of the spring hung to a wire (about 3 inches
long), reassemble the spring around the Reference
Plate (B).
2. Pass the wire behind the bearing for the plate.
4. Hook one side of spring while pulling the other side of
the wire. Then, hook the other side of the spring.
5. Remove the wire.
To Next Page
Loading...
