Panasonic KX-F680BX - Adjusting the Feeder Pressure; Confirmation of Separation Spring; Table of Test Equipments and Tool

|97 |
ADJUSTMENT
KX-F680BX/KX-F2681BX
SPRING HEIGHT TOOL
(PFZZ2F780M)
SEPARATION SPRING
NO TOUCH
SPRING HEIGHT TOOL
(PFZZ2F780M)
SEPARATION SPRING
TOUCH
1. TABLE OF TEST EQUIPMENTS AND TOOL
2. ADJUSTING THE FEEDER PRESSURE
If misfeeding of document, such a multiple feeding or no feeding, occurs frequently, try to adjust the feeder pressure by
following steps below.
(1) Open the front lid by pressing the front lid open.
(2) Shift the position of the lever by using an instrument
with a pointed end, like a clip or ball-point pen.
Position A: Select this when documents do not feed.
Position B: Standard position (pre-selected)
Position C: Select this when documents multiplefeed.
(3) Close the front lid by gently pressing down on both ends.
3. CONFIRMATION OF SEPARATION SPRING
1. Open the operation grille.
2. Check the highest level of the separation spring with the
spring height tool (PFZZ2F780M). Please make sure that
the separation spring does not touch the tool during this
operation. (Both right and left) (See Fig. 1).
3. Check the lowest level of the separation spring with the
opposite side of the spring height tool. Please make sure
that the separation spring touches the tool during this
operation. (Both right and left) (See Fig. 2).
AC
B
Front lid open
button
Lever
No.
1
2
3
4
Test Equipment and Jig Name
Jig No.
Oscilloscope
CCD Tool
Extension Cord
Spring Height Tool
PFZZ1F780M
PQZZ2K12Z, PQZZ8K18Z
PFZZ2F780M
Fig. 1
Fig. 2