6 TROUBLESHOOTING GUIDE
6.1. USER RECOVERABLE ERRORS
If the unit detects a problem, one or more of the following messages will appear on the display.
The explanations given in the [ ] are for servicemen only.
DISPLAY MESSAGE CAUSE AND REMEDY
•
• •
• Polygon motor error.
Refer to CALL SERVICE 1 (P.84).
•
• •
• Laser beam error. Replace LSU unit.
Refer to CALL SERVICE 2 (P.85).
•
• •
• Fuser unit cannot heat up. Replace fuser unit.
Refer to CALL SERVICE 3 (P.86).
•
• •
• Fan motor error. Replace fan motor.
Refer to CALL SERVICE 4 (P.87).
•
• •
• There is something wrong with the drum unit. Replace the drum unit and the toner cartridge.
•
• •
• The document is not fed into the unit properly. Reinsert the document. If misfeeding occurs frequently,
clean the document feeder rollers and try again.
•
• •
• The drum unit is not inserted properly. Reinsert it correctly.
•
• •
• The installed drum is worn out. Replace the drum unit with a new one.
•
• •
• The memory (telephone numbers, parameters, etc.) has been erased. Re-program.
•
• •
• The front cover is open. Close it.
•
• •
• There is no space to store new entries in navigator directory. Erase unnecessary entries.
•
• •
• The drum life is complete. Replace the drum unit immediately.
•
• •
• Recording paper was not fed into the unit properly. Reinsert the recording paper.
•
• •
• The unit has a document in memory. See the other displayed message instructions to print out the
document.
•
• •
• The memory is full of received documents due to lack of recording paper or a recording paper jam, etc.
Install paper or clear the jammed paper.
•
• •
• When performing memory transmission, the document being stored exceeds the memory capacity of the
unit. Transmit the entire document manually.
•
• •
• The inside of the unit is extremely cold and cannot be operated. Use the unit in a warmer area. While the
unit cannot be operated, the received documents are temporarily stored into the memory, and will be
printed out automatically when the unit warms up.
•
• •
• When making a copy, the document being stored exceeds the memory capacity of the unit. Press STOP
to clear the message. Divide the document into sections.
•
• •
• There is something wrong with the modem circuit.
•
• •
• The other party´s fax machine is busy or has run out of recording paper. Try again.
•
• •
• Recording paper is not installed or the unit has run out of paper. Install paper.
•
• •
• Recording paper is not fed into the unit properly. Reinstall paper.
•
• •
• A recording paper jam occurred. Clear the jammed paper.
[If the printout jams, please refer to RECORDING PAPER JAMS (P.36).]
•
• •
• The unit is warming up. Wait for a while.
•
• •
• The other party’s fax machine does not offer the polling function. Check with the other party.
•
• •
• The other party´s fax machine is busy or has run out of recording paper. Try again.
59
KX-FL612CX / KX-FL612CX-S