Code Function Set Value Default Remote
Setting
718 Receive speed select 1:14400/ 2:12000/ 3:9600/ 4:7200/
5:4800/ 6:2400
14400bps OK
721 Pause tone detect 1:ON / 2:OFF OFF OK
722 Redial tone detect 1:ON / 2:OFF ON OK
763 CNG detect time for friendly reception 1:10s / 2:20s / 3:30s 30s OK
771 T1 timer 1:35s / 2:60s 35s OK
774 T4 timer 00~99 × 100msec 00 OK
815 Sensor test --------- --------- NG
852 Print test pattern --------- --------- NG
853 Top margin 1~5 3 OK
854 Left margin 1~7 4 OK
874 DTMF ON time 060~200msec 90 OK
875 DTMF OFF time 060~200msec 90 OK
880 History list 1:Start --------- NG
881 Journal 2 --------- --------- NG
882 Journal 3 --------- --------- NG
991 Setup list 1:Start --------- OK
994 Journal list 1:Start --------- OK
995 Journal 2 list 1:Start --------- OK
996 Journal 3 list 1:Start --------- OK
998 History list 1:Start --------- OK
999 Service list 1:Start --------- OK
OK means “can set”.
NG means “can not set”.
Note:
Refer to SERVICE FUNCTION TABLE (P.62) for descriptions of the individual codes.
Example:
If you want to set value in the “004 Transmission report mode”, press the dial key number 1, 2 or 3 corresponding to the Set
Value you want to select. (1:ERROR/2:ON/3:OFF)
70
KX-FL612CX / KX-FL612CX-S
To Next Page
Loading...
