Panasonic KX-FL612CX - Recording Paper Feed Issues; 6.5.5.2 Recording Paper Feed Issues

6.5.5.2. RECORDING PAPER FEED
No. Symptom Cause Countermeasure
1 MULTIPLE FEED (P.96) Dirty or failed the pickup roller Clean or replace the pickup roller
Dirty or failed the pickup rubber Clean or replace the separation rubber
2 THE RECORDING PAPER
IS WAVED OR WRINKLED
(P.96)
Dirty the pressure roller or the heat roller Clean the pressure roller and the heat roller
Failed the spring of pressure roller Replace the spring of pressure roller
Too thin recording paper Use the recording paper from 16lb to 24lb
3 SKEW (P.97) Dirty or failed the pickup roller Clean or replace the pickup roller
Dirty or failed the pickup rubber Clean or replace the separation rubber
Dirty or failed the paper feed roller Clean or replace the regist roller
Dust on the recording paper path Clean the recording paper path
Failed LSU Replace LSU
Over the max capacity of the recording paper Set up to MAX 150 sheets
Too thick or too thin recording paper Use the recording paper from 16lb to 24lb
4 THE RECORDING PAPER
DOES NOT FEED (P.98)
Dirty or failed the pickup roller Clean or replace the pickup roller
Dirty or failed the pickup rubber Clean or replace the separation rubber
Failed the gear Check the gear
Failed the engine motor Go to ENGINE MOTOR (P.135)
Failed the paper feed sensor lever Check the regist sensor (paper top sensor) lever
Failed the paper feed sensor -----
5 THE RECORDING PAPER
JAM(P.99)”PAPER
JAMMED” ON THE LCD
Dirty or failed the pressure roller Clean or replace the pressure roller
Dirty or failed the heat roller Clean or replace the heat roller
Dust on the recording paper path Clean the recording paper path
Failed the paper feed roller Replace the regist roller
Failed the gear Check the gear
Failed the engine motor Go to ENGINE MOTOR (P.135)
Failed the paper feed sensor lever Check the regist sensor (paper top sensor) lever
Failed the paper feed sensor -----
Failed the exit sensor lever Check the exit sensor lever
Failed the exit sensor Go to PAPER EXIT SENSOR..... “PAPER JAMMED” (P.179)
Too thick or too thin recording paper Use the recording paper from 16lb to 24lb
Not set the toner bottle Set toner bottle
6 BACK SIDE OF THE
RECORDING PAPER IS
DIRTY(P.101)
Dirty the recording paper path Clean the recording paper path
Dirty the pressure roller Clean the pressure roller
Dirty the regist roller Clean the regist roller
Failed the high-voltage terminal Check the high-voltage terminal
Failed the high voltage power supply board Go to HIGH VOLTAGE SECTION (P.140)
80
KX-FL612CX / KX-FL612CX-S