-10-
(Model KX-FT21BX/KX-FT21BX-W)
KX-FT21BX/KX-FT21BX-W
Code Function Set Value
Effective Range
Default Remarks
591
Setting the FAX redial
interval
001~999 sec 001~999 045 sec
Sets the FAX redial interval during FAX
communication.
Lets you select the CNG output during
FAX transmission.
1: OFF ALL: CNG is output at phase A.
592 2: ALL 1, 2, 3 ALL AUTO: CNG is output only when
3: AUTO automatic dialing is
performed.
OFF: CNG is not output at phase A.
593
Setting the interval
between CED and the
300 bps signal
1: 75 msec 2:500
msec 3:1000
msec
1, 2, 3 75 msec
Sets the interval between the CED
signal and subsequent 300 bps
signal.
Sets the recognition format of the DIS
signal.
1: Detects on the 1:Detects the first DIS signal sent
594 1st time. Detects from the receiver during FAX
2: Detects on the 1, 2 on the transmission.
2nd time. 1st 2:Ignores the first DIS signal sent
time. from the receiver during FAX
transmission.
595
Setting an acceptable
reception error value
001~999 X number
of times
001~999 100
Sets the number of acceptable error
lines when the FAX reconstructs the
received data.
596
Setting the transmit
level
- 15~00 - 15~00 - 10 dBm
Selects the FAX transmission level.
(Increase the level when the telephone
line condition is poor.)
598 Modem sensitivity 20~48 45 See page 42.
717 Transmit speed select
1:9600BPS
2:7200BPS
3:4800BPS
4:2400BPS
1~4 9600 BPS
Adjusts the speed to start training
during FAX transmission.
718 Receive speed select
1:9600BPS
2:7200BPS
3:4800BPS
4:2400BPS
1~4 9600 BPS
Adjusts the speed to start training
during FAX reception.
719
Ringer off in TEL/FAX
mode
1:ON 2:OFF 1, 2 ON
Sets the ringer switch off when a call is
received in the TEL/FAX mode.
721 Pause tone detect 1:ON 2:OFF 1, 2 ON
Selects the tone detection for pauses
in dialin
.
722 Redial tone detect 1:ON 2:OFF 1, 2 ON
Selects the tone detection mode after
redialin
.
763 CNG detect time
1:10 sec 2:20 sec
3:30 sec
1, 2, 3 20 sec
Selects the CNG detection time of
friendl
reception.
771 T1 timer 1:35 sec 2:60 sec 1, 2 35 sec
Sets a higher value when the response
from the other party needs more time
during FAX transmission.
774 T4 timer 00~99 (X100ms) 00~99 00
Use this function when delay occurs
on the line and communication does
not work well.
815 Sensor check Press "START".
844 Original setting
1:NORMAL
2:LIGHT
3:DARKER
1, 2, 3 NORMAL
Use this feature when you need to
transmit and copy a document with very
faint writing or very dark writing.
Designation of CNG
sending
Setting the overseas
DIS detection
4-4. Service Function Table (Change from original page 86)
To Next Page
Loading...
