1. Installation and Quick Start
4
1 Installation an d Quick StartAccess ories
1.1 Included accessories
Note:
L If any items are missing or damaged, contact the
place of purchase.
L Save the original carton and packing materials for
future shipping and transportation of the unit.
1.2 Accessory information
1.2.1 Available accessories
– Standard thermal recording paper
*1
(KX-A106):
216 mm × 30 m roll, with 25 mm core
*1 Use only the included or specified recording
paper. Using other recording paper may affect
print quality and/or cause excessive wear to the
thermal head.
Connec tions and Set up
1.3 Connections
Important:
L The unit will not function when there is a power
failure. To make calls in emergency situations,
you should connect a telephone that can
function during a power failure to the telephone
line.
Caution:
L When you operate this product, the power outlet
should be near the product and easily
accessible.
L Be sure to use the telephone line cord included in
this unit.
L Do not extend the telephone line cord.
L Keep the unit away from walls as far as possible
to prevent a recording paper jam.
Note:
L Before you can make calls, the dialling mode setting
may need to be changed (page 11).
1 Telephone line cord 2 Handset
3 Handset cord 4 Recording paper
(10 metres long)
5 Paper stacker
(KX-FT938 only)
6 Operating instructions
1 Paper stacker (KX-FT938 only)
L The paper stacker may not be shown in all
illustrations in these operating instructions.
2 Power cord
L Connect to the power outlet (220 V – 240 V, 50/60
Hz).
3 Telephone line cord
L Connect to [LINE] jack and a single telephone
line jack.
4 [EXT] jack (KX-FT932 only)
L Remove the stopper if attached.
5 Handset cord
6 Extension telephone (not included)
4
6
3
2
5
1
FT932-938FX_PFQX2588ZA-en.book Page 4 Thursday, June 15, 2006 8:30 AM
To Next Page
Loading...
