Panasonic KX-FT932FX

11. General Information
47
Specifications
11.2 Specifications
■ Applicable lines:
Public Switched Telephone Network
■ Document size:
Max. 216 mm in width, Max. 600 mm in length
■ Effective scanning width:
208 mm
■ Recording paper size:
216 mm × max. 30 m roll
■ Effective printing width:
208 mm
■ Transmission time
*1
:
Approx. 15 s/page (Original mode)
*2
■ Scanning density:
Horizontal: 8 pels/mm
Vertical: 3.85 lines/mm – in standard resolution,
7.7 lines/mm – in fine/photo resolution,
15.4 lines/mm – in super fine resolution
■ Photo resolution:
64-level
■ Scanner type:
Contact Image Sensor
■ Printer type:
Thermal printing
■ Data compression system:
Modified Huffman (MH), Modified READ (MR)
■ Modem speed:
9,600 / 7,200 / 4,800 / 2,400 bps; Automatic Fallback
■ Operating environment:
5 °C – 35 °C, 20 % – 80 % RH (Relative Humidity)
■ Dimensions:
Approx. height 121 mm × width 352 mm × depth 224 mm
■ Mass (Weight):
KX-FT932: Approx. 2.7 kg
KX-FT938: Approx. 2.8 kg
■ Power consumption:
Standby: Approx. 1.5 W (KX-FT932)
Standby: Approx. 1.8 W (KX-FT938)
Transmission: Approx. 13 W
Reception: Approx. 30 W (When receiving a 20 % black
document)
Copy: Approx. 35 W (When copying a 20 % black
document)
Maximum: Approx. 110 W (When copying a 100 % black
document)
■ Power supply:
220 V – 240 V AC, 50/60 Hz
■ Fax memory capacity
*3
:
Approx. 28 pages of memory reception
(Based on the ITU-T No. 1 Test Chart in standard
resolution, with original mode.)
■ Voice memory capacity
*4
(KX-FT938 only):
Approx. 18 minutes of recording time including greeting
message when no documents are in memory
*1 Transmission speed depends upon the contents of
the pages, resolution, telephone line conditions and
capability of the other party’s machine.
*2 Transmission speed is based upon the ITU-T No. 1
Test Chart with original mode. If the capability of the
other party’s machine is inferior to your unit, the
transmission time may be longer.
*3 If an error occurs during fax reception, such as a
paper jam or if the recording paper runs out, the fax
and subsequent faxes will be retained in memory.
*4 Recording time may be reduced by the calling party’s
background noise.
ITU-T No. 1 Test Chart
Note:
L Design and specifications are subject to change
without notice.
L The pictures and illustrations in these instructions
may vary slightly from the actual product.
L The suffix in the model number will be omitted in
these instructions.
L Most figures shown in these operating instructions
are based on a KX-FT932.
FT932-938FX_PFQX2588ZA-en.book Page 47 Thursday, June 15, 2006 8:30 AM