M
Maurice ButlerAug 14, 2025
How to reset Panasonic Telephone Accessories?
- CCynthia BryantAug 14, 2025
To perform a reset operation for Panasonic Telephone Accessories, turn the Power Switch off and then on again.
To Next PageTo Next PageHow to reset Panasonic Telephone Accessories?
To perform a reset operation for Panasonic Telephone Accessories, turn the Power Switch off and then on again.
Why does my Panasonic KX-TA308 not ring?
Your Panasonic PBX might not be ringing because an outside (CO) line number is not programmed, or the Ringer Volume is set to “OFF”. Increase the Ringer Volume referring to “Initial Settings”.
How to fix Panasonic Telephone Accessories speed dialing not working?
If Speed Dialing or One-Touch Dialing isn't working on your Panasonic Telephone Accessories, the programming might be incorrect. Ensure that you enter an outside (CO) line access number (9, 81 through 83) during programming.
What to do if Panasonic Telephone Accessories extension does not operate?
If an extension on your Panasonic Telephone Accessories system isn't working, there could be a few reasons. It could be a connection issue between the system and the extension, a telephone with an A-A1 relay connected, or an issue with the extension itself. Here are a few things you can try: * Plug the extension into the same extension port using a short telephone cord. If it works, repair the connection between the system and the extension, using a 2 wire cord. * If you are using a telephone with an A-A1 relay, set the switch to the “OUT” or “OFF” position. * Plug the extension into another extension port that is working. If it still doesn't work, replace the phone.
Why is there noise during external paging on my Panasonic Telephone Accessories?
If you're experiencing noise during external paging with your Panasonic Telephone Accessories, it might be due to induced noise on the wire between the system and the amplifier. Try using a shielded cable as the connection wire between the system and the amplifier. A short shielded cable is recommended.
What to do if Panasonic Telephone Accessories proprietary telephone does not operate?
If a proprietary telephone connected to extension jacks 01 through 08 isn't working, but a single line telephone is, an extension (H, L) jack 01 through 08 may have been shorted. Turn the Power Switch off, fix the shorted part, and then turn the Power Switch back on.
Why is there volume distortion from external music source on Panasonic Telephone Accessories?
If you notice volume distortion from an external music source connected to your Panasonic Telephone Accessories, it's likely due to an excessive input level from the external music source. Decrease the output level of the external music source by using the volume control on the music source.
What to do if Panasonic Telephone Accessories SLT user cannot make a call?
If a tone type single line telephone (SLT) user is unable to make calls on your Panasonic Telephone Accessories, the issue might be with a DTMF receiver. Here’s how you can troubleshoot: 1. In program [107], select “Enable” for DTMF receiver 1 and “Disable” for DTMF receiver 2. 2. Try making a call using a tone type SLT connected to one of the extension jacks 01 – 08. If the call fails, DTMF receiver 1 may be the problem. If the call is successful, proceed to step 4. 3. Try DTMF receiver 2. In program [107], select “Disable” for DTMF receiver 1 and “Enable” for DTMF receiver 2, then attempt another call. If the call fails again, DTMF receiver 2 may be the cause.
Why doesn't the extension connected to JACK 01 operate during a power failure on Panasonic Telephone Accessories?
If the extension connected to JACK 01 doesn't work during a power failure with your Panasonic Telephone Accessories, it might be because a PT (proprietary telephone) is connected to the jack. Disconnect the PT and connect a single line telephone instead.
General| Direct Inward System Access (DISA) | Yes |
|---|---|
| Caller ID Compatibility | Yes |
| Uniform Call Distribution (UCD) | Yes |
| Doorphone Interface | Yes |
| Battery Backup | Optional |
| Wireless Handsets | No |
| Call Waiting | Yes |
| Intercom | Yes |
| Conference | Yes |
| Type | Hybrid PBX |
| Capacity | 3 CO lines and 8 extensions |
| Expandable | Yes |
| Dimensions | 368 x 284 x 102 mm |
| Weight | Approx. 2.2 kg (4.9 lbs) |
