2.11 Starting the PBX
Installation Manual 105
5. While the RUN indicator is flashing, slide the System Initialize Switch back to the "NORMAL" position.
Depending on the configuration, initialization takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and stay lit.
All data will be cleared, and the PBX as well as all optional service cards will be initialized to the default
values.
IMPORTANT
Use only the AC adaptor (Panasonic PSLP1244/Panasonic PSLP1434) and AC cord supplied
with the PBX.
LED Indications
Confirming the CO Line Connection
After initialization, program the PBX and connect CO lines to the PBX.
To confirm that the CO lines are successfully connected, dial [ ] [3] [7] + CO line number (3 digits) on an
APT, or press the APT's S-CO button. You will hear a dial tone if CO line is available and connected.
Turning off the PBX
For safety reasons, make sure to turn off the power switch before unplugging the PBX. To unplug, follow the
reverse steps to plug it in.
Indication Color Description
RUN Green PBX status indication
• OFF: Power off (includes normal reset)
• ON: Power on and running (on-line)
• Flashing (60 times per minute): Starting up
• Flashing (120 times per minute): Starting up or resetting with:
• the System Initialize Switch in "SYSTEM INITIALIZE"
position
• the SD Memory Card not inserted
ALARM Red Alarm detection status indication
• OFF: Normal
• ON: Alarm (CPU stop, alarm for each optional service card)
• Flashing: Alarm (MPR file error in restarting)
To Next Page
Loading...
