Panasonic KX-TAW848 - Installation of the PC Programming Software; Installing and Starting the KX-TAW848 Maintenance Console

3.3 Installation of the PC Programming Software
Installation Manual 111
3.3 Installation of the PC Programming Software
3.3.1 Installing and Starting the KX-TAW848 Maintenance
Console
System Requirements
Required Operating System
• Microsoft Windows 98 SE, Windows Me, Windows 2000, or Windows XP
Minimum Hardware Requirements
• CPU: 300 MHz Intel Celeron microprocessor
• HDD: 100 MB of available hard disk space
• RAM: 128 MB of available RAM
Installing the KX-TAW848 Maintenance Console
Notes
• Make sure to install and use the latest version of the KX-TAW848 Maintenance Console.
• To install or uninstall the software on a PC running Windows 2000 Professional or Windows XP
Professional, you must be logged in as a user in either the "Administrators" or "Power Users" group.
• To connect the PC to the PBX via USB, the KX-TDA USB driver must be installed. Follow the
instructions of the wizard to install the KX-TDA USB driver. When the PBX is first connected to the
PC via USB, you may be asked to select the appropriate USB driver. Browse for and select the KX-
TDA USB driver that was installed previously.
1. Copy the setup file of the KX-TAW848 Maintenance
Console to your PC. (Its icon is shown here, on the
left.)
2. Double-click the setup file to run the installer.
3. Follow the on-screen instructions provided by the
installation wizard.
®®
®®