2.2 Installation of the PBX
Installation Manual 39
3. Insert the new extension bolt (included with the card) into the hole on the card, and tighten it to secure
the card.
4. Stick an appropriate optional card label (included) to the left side of the corresponding card.
5. Connect a cable to an appropriate port of the card.
For details about pin assignments, refer to the appropriate section in "2.3 Information about the CO Line
Cards" and "2.4 Information about the Extension Cards".
Note
Make sure to connect cables after installing the card in the PBX, not before.
Extension Bolt
Optional Card Label
To Next Page
Loading...
