Panasonic KX-TCD300FXS

15 THINGS TO DO AFTER REPLACING IC
Cautions:
Since this page is common to each country, it may not apply to some models in your country. The contents below are the
minimum adjustments required for operation.
15.1. Base Unit
IC Necessary Adjustment TCD300
BBIC Programs for Voice processing, interface for RF and
EEPROM
1. Default batch file: Excute the command
“default.bat”.
2. Country version batch file: Excute the command
“TCD210FXrev025_14_3.bat”.
3. Clock adjustment: Refer to Check Point (F). (*1)
need
EEPROM Adjustment parameter data
(country version batch file, default batch file, etc.)
1. Change the address of EEPROM from “0000” to
“AA”.
2. Default batch file: Excute the command
“default.bat”.
3. Country version batch file: Excute the command
“TCD210FXrev025_14_3.bat”.
4. Clock adjustment: Refer to Check Point (F). (*1)
need
FLASH 1 Voice prompt data
(vary depending on country version)
Nothing -
FLASH 2 Program Nothing -
Note:
(*1) Refer to Check Point (Base Unit) (P.52)
15.2. Handset
IC Necessary Adjustment TCD300
BBIC Programs for Voice processing, interface for RF and
EEPROM
1. Default batch file: Excute the command
“default.bat”.
2. Country version batch file: Excute the command
“TCA130FXrev020_15.bat”.
3. Clock adjustment: Refer to Check Point (I). (*2)
4. 1.8 V setting and battery low detection: Refer to
Check Point (A), (G) and (H). (*2)
need
EEPROM Adjustment parameter data
(country version batch file, default batch file, etc.)
1. Default batch file: Excute the command
“default.bat”.
2. Country version batch file: Excute the command
“TCA130FXrev020_15.bat”.
3. Clock adjustment: Refer to Check Point (I). (*2)
4. 1.8 V setting and battery low detection: Refer to
Check Point (A), (G) and (H). (*2)
need
FLASH 2 Program Nothing -
Note:
(*2) Refer to Check Point (Handset) (P.59)
65
KX-TCD300FXS / KX-TCD300FXT / KX-TCA130FXS / KX-TCA130FXT