Panasonic KX-TCD951EB - Turning the Power on

Settings
12
-i-
Turning the Power ON
To turn the power OFF, press and hold
until a beep sounds.
•The display will go blank.
•The handset will not ring.
•Depending on the programming mode, you
may not be able to turn the power off. First
make sure the handset is set to the stand-by
mode.
PWR
•You can choose whether to display the base
unit number, handset number or no display in
the stand-by mode by programming (p. 34).
Press .
•After all possible configurations briefly appear,
the display will change to the following.Then
the handset is in the stand-by mode.
The current connected base unit number is
displayed.
PWR
Display
Power Button
PWR
KX-TCD951EB(008~015) 99.6.16 5:37 PM Page 12