Panasonic KX-TCD951EB - Chapter 2 Basic Operations; Making Calls

16
To select the receiver volume
3 levels (HIGH, MEDIUM, LOW) are available.
The factory preset is MEDIUM.
While talking, press
F or G to select the
desired level.
•After a few seconds, the display will return to
the length of call.
OR
In the stand-by mode, proceed as follows.
1 Press .
2 Press G or F until “ F6 ” is displayed,
then press .
•The current level is displayed.
3 Press F or G to select the desired
level.
4 Press .
PROG
OK
PROG
To dial after confirming the
entered number
1 Enter a phone number.
•The entered number is displayed.
•If you misdial, press . Digits are
erased from the right.
•To cancel, press firmly.
•
If your line has rotary or pulse service, any
access numbers entered after pressing
will not be included when dialling.
2 Press .
•After a few seconds, the display will start
showing the length of the call.
3 To hang up, press or place the
handset on the base unit.
•The handset will return to the stand-by
mode.
C
C
Making Calls
1 Press .
2 Dial a phone number.
•The dialled number is displayed.
•After a few seconds, the display will start
showing the length of the call.
•If “ ” flashes and an alarm tone sounds
after pressing , move closer to the
base unit.Then try again.
•You can choose whether to display the length
of the call or phone number in the talk mode
by programming (p. 28).
3 To hang up, press or place the
handset on the base unit.
•The handset will return to the stand-by
mode.
Ex. LOW is selected.
Make sure that the power is ON (p. 12).
i2345678
888800-00-00
F6
Ex. LOW is selected.
KX-TCD951EB(016~021) 99.6.16 7:09 PM Page 16