Panasonic KX-TCD951EB - Conference; Setting the Call Waiting Tone

38
Paging/Intercom
3 Handset 1:
Press to establish a conference call.
4 Handset 1 or 2:
Press to hang up the conference
call.
3
Setting the Call Waiting Tone
If an incoming call has been received during an intercom between handsets, a call waiting tone
sounds.You can choose whether or not this tone will sound. The factory preset is ON.
Conference
During a call using the handset, you can make an intercom call to another handset and then combine
the calls together to establish a conference call between handsets registered to the same base unit.
1 Handset 1:
During a call, press .Then enter
the desired handset number.
•The call is put on hold.
•If there is no answer, press to
return to the call.
2 Handset 2:
When the unit rings, press to
answer.
INT
INT
1 Press .
2 Press G or F until “ F24 ” is displayed.
3 Press .
•The current setting is displayed.
1: ON 0: OFF
4 Press G or F to select the desired
setting.
•You can press or to select OFF
or ON.
1
0
OK
PROG
5 Press .
•A confirmation tone sounds and the
display will return to the stand-by mode.
PROG
F24U i
Ex. ON
KX-TCD951EB(036~044) 99.6.16 5:39 PM Page 38