Panasonic KX-TCD951EB - Direct Call; Setting the Direct Call Mode; Dialling the Stored Number

24
Direct Call
You can store a number in the direct call memory. This feature allows you to make a call easily by
pressing . Incoming calls are accepted.
Setting the Direct Call Mode
After storing the direct call number, the unit will automatically switch to the direct call mode.
1 Press .
2 Press G or F until “ F42 ” is displayed.
3 Press .
•If the current stored number is the same
as the number you wish to set, skip to step
5.
4 Enter the phone number, up to 24 digits.
•If you misdial, press .The digits are
erased from the right.To erase all digits,
press firmly.
5 Press .
•A confirmation tone sounds.
•The display will return to the stand-by
mode, then “ ” is displayed.
PROG
C
C
OK
PROG
To change the direct call number:
Enter the new direct call number in step 4.
To turn OFF the direct call
mode
1 Press .
2 Press G or F until “ F42 ” is displayed.
3 Press .
4 Press .
•“ ” will go out.
PROG
OK
PROG
Dialling the Stored Number
Make sure that “ ” is displayed, then press .
•The number stored in the direct call memory is dialled automatically.
F42 -
-i-
KX-TCD951EB(022~029) 99.6.16 5:38 PM Page 24