Why does the battery icon flash on my Panasonic Telephone after charging?
If you charged the batteries fully, but the battery icon continues to flash on your Panasonic Telephone, try cleaning the charge contacts and charge again. If the issue persists, it may be time to replace the batteries with new ones.
What to do if outside lines are connected to the T2 / T1 on Panasonic PBX?
Reconnect the outside lines to the T1 / R1 or T2 / R2 of the telephone jack using 2-conductor wiring.
How to fix static and sound issues on Panasonic Telephone?
If you are experiencing static, sound cuts in/out, or fading on your Panasonic Telephone, or if there is interference from other electrical units, try setting the PS and CS away from other electrical appliances. Also, try moving closer to the CS.
What to do if I cannot make or receive calls on my Panasonic Telephone System?
If you're unable to make or receive calls on your Panasonic Telephone System, it could be due to the handset being out of range. Try moving closer to the base unit. Also, ensure the telephone line is properly connected.
Why does my Panasonic Telephone System say 'No Service'?
If your Panasonic Telephone System displays 'No Service', it could be due to a couple of reasons. First, the handset might be out of range, so try moving closer to the base unit. Alternatively, the base unit might be turned off, so ensure the power cord is properly connected.
Why can't I dial on my Panasonic Telephone System?
If you cannot dial on your Panasonic Telephone System, it could be because the number you dialed is restricted by the PBX; in this case, consult your dealer. Alternatively, the key lock mode might be on. To cancel it, press the Joystick for about 2 seconds.
Why does my Panasonic Telephone System not store all received calls in the Incoming Call Log?
If some received calls are not stored in the Incoming Call Log of your Panasonic Telephone System, it is because incoming calls via Voice Call/Paging/LCS/Auto Answer cannot be stored. Set at least one of the incoming call types to On.
What does "REGISTER UNIT" mean on Panasonic Telephone?
If your Panasonic Telephone displays "REGISTER UNIT", it means the PS is not registered in the system. Consult your dealer.
Why is my Panasonic Telephone PS not working?
If your Panasonic Telephone's PS does not work, it could be because the battery is empty. In this case, charge the batteries fully. If the PS has been cancelled or not registered, you should consult your dealer.
Why can't I dial on my Panasonic Telephone?
If you cannot dial on your Panasonic Telephone, it might be because the number you dialed is restricted by the system, so you should consult your dealer. Alternatively, the key lock mode might be set. To cancel the mode, press the Function button for about 2 seconds. Also, the radio channel might be busy or a radio communication error occurred, so try again later.
General| Type | Hybrid PBX |
|---|---|
| Max CO Lines | 12 |
| Max Extensions | 32 |
| Power Supply | AC 120V, 60Hz |
| Caller ID | Yes |
| DISA/OGM | Yes |
| SMDR | Yes |
| Operating Temperature | 0°C to 40°C |
To Next Page