3.3 Installation of the KX-TDA Maintenance Console
162 Installation Manual
Starting the KX-TDA Maintenance Console and Assigning the Basic
Items (Quick Setup)
When you start the KX-TDA Maintenance Console with the Installer Level Programmer Code and connect
to the Hybrid IP-PBX for the first time after initialization (with the factory default setting), Quick Setup will
launch automatically. During Quick Setup, you will setup the following basic items:
• Date and Time of the Hybrid IP-PBX. The date and time set on the PC will be used.
• System Password for installer for PC programming.
• Operator extension numbers. Operator extensions for all time modes (day/lunch/break/night) can
be assigned.
• Flexible Numbering type to pattern 1 or pattern 2. If pattern 1 (with ) is selected, " " must prefix
all feature numbers (except access numbers) when an extension user wants to use a feature.
• Operator call and Idle Line Access/ARS numbers (0 or 9). The feature numbers for operator call
and Idle Line Access/ARS can be selected.
• Remote Maintenance Dial Number. Enter the complete telephone number of the Hybrid IP-PBX
(including the country code). When necessary, this number will be used to access the Hybrid IP-
PBX from a remote location for maintenance purposes.
1. Connect the PC to the Hybrid IP-PBX with a USB cable.
2. Start the KX-TDA Maintenance Console from the Start
menu.
3. Type the Installer Level Programmer Code (default:
INSTALLER), then click [OK].
The Programmer Code authorizes different programming
levels, and the Quick Setup is only available when you start
the KX-TDA Maintenance Console with the Installer Level
Programmer Code.
Note
There are 2 other Programmer Codes with limited
authorization: Administrator Level (default: ADMIN),
and User Level (default: USER).
4. Click "Connect" → "USB" from the menu bar.
To Next Page
Loading...
