Panasonic KX-TDA100 KX-TDA200 - Page 177

4.1 Troubleshooting
Installation Manual 177
016 CS overload • Defective cable
• CS malfunction
• Optional service card
malfunction: CSIF
• Check the cable diameter and length
• Replace the CS
• Replace the corresponding optional
service card
020* SD file access
error
• SD Memory Card malfunction
• Bad connection of SD
Memory Card
• MPR card malfunction
• Press the Reset Button
• Reprogram the Hybrid IP-PBX
• Replace the SD Memory Card
• Replace the MPR card (be sure to turn
off the Hybrid IP-PBX when replacing)
021* SD Memory Card
disconnected
• SD Memory Card not
installed
• Bad connection of SD
Memory Card
• SD Memory Card malfunction
• MPR card malfunction
022 Not enough free
space on SD card
• Not enough memory space
available to save the system
data, or to upload system files
from the KX-TDA
Maintenance Console
• Delete the files whose file names start
with "$" from SD Memory Card
• Delete the "Pxxx" files (old program
files of optional service cards) from SD
Memory Card. "xxx" indicates the card
type (e.g., "PDHLC" for DHLC card)
Note
Do not delete the "PMPR" file; it is the
program file of the MPR card.
023 System data file
version error
• Old system files on SD
Memory Card
• Defective system files on SD
Memory Card
• Restore the backup files
• Re-install the software
024 System
initialization file
version error
025 Card initialization
file version error
026 LCD file version
error
027 System data file
checksum error
028 System
initialization file
checksum error
029 Card initialization
file checksum
error
030 LCD file
checksum error
Error Code Error Message PROBABLE CAUSE SOLUTION