Panasonic KX-TDA30 - Page 41

When Assigning IP Addresses to IP-PTs Without Using a DHCP Server
If you are
not using a DHCP server on the network, you will have to set an IP address and subnet mask address
to the IP-PT, in addition to the PBX IP address. If necessary, also enter the IP address of the default gateway.
Follow the procedure below for all IP-PTs on the network, using appropriate IP addressing information.
If you need to set VLAN parameters, follow the procedure described in "4.2.2 Setting the VLAN
Parameters" after assigning the IP addresses without ending programming.
IP-PTs with a multiline display (e.g., KX-NT300 series [except KX-NT321])
Select "Network".
ENTER
Select "Disable"
for DHCP setting.
ENTER
IP Address*
1
ENTER
To set the IP address of the IP-PT
To set the subnet mask address
Select "Default Gateway".
ENTER
Default Gateway Address*
3
ENTER
ENTER
Subnet Mask Address*
2
ENTER
Select "Subnet Mask".
Select "IP Address".
To start programming
Press "SETUP" when it is displayed.
SETUP
Supply power to the IP-PT.
Select "PBX".
Return to the
Menu screen.
PBX IP Address
ENTER
ENTER
To enter the IP address of the IP-EXT card (PBX IP Address)
Select "PBX IP
Address".
Select "Primary
PBX".
ENTER
ENTER
KX-NT300 with software version 2.00 or later only
Continued on next page
To set the default gateway address (if required)
Information about IP Proprietary Telephones 41
4.2.1 Assigning the IP Addressing Information