Panasonic KX-TDA30

3.3.2 Connecting the IP Proprietary Telephones
When an IP-PT is connected to the LAN and power is supplied for the first time, you will be prompted to set
network parameters. The network parameters must be set for the IP-PT before it can be used. Refer
to "4.2 Programming the IP Proprietary Telephone" for instructions.
Note
The connection example shown here is for the KX-NT136 IP-PT.
Connecting an IP-PT to a Switching Hub
When connecting an IP-PT to the LAN, connect it to a switching hub.
Note
• Use an Ethernet straight cable with an RJ45 connector to connect the IP-PT to a switching hub. The
cable should be a 100BASE-TX CAT 5 (Category 5) or higher cable.
• When using the VLAN feature on the network, make sure that the switching hub to be connected is
IEEE 802.1Q compliant and is configured for VLANs. In addition, the port of a switching hub that the
IP-PT is connected to must be set to "Trunk" port, to allow VLAN tagging. Consult your network
administrator for details.
To a switching hub
Ethernet Straight Cable
LAN
Information about IP Proprietary Telephones 31
3.3.2 Connecting the IP Proprietary Telephones