Panasonic KX-TDA50

• The hotel operator must be using a 6-line display PT to use the Room Status Control features.
• While in Room Status Control mode:
a. The hotel operator’
s extension can only check extensions in/out and ready/not ready. All
other operations will be ignored.
b. The light of each DSS button shows the room status of the corresponding extension as
follows:
For the KX-TDA50/KX-TDA100/KX-TDA200
Off: Checked-out and Ready
Flashing Red: Checked-out and Not Ready
Red on: Checked-in
For the KX-TDA600
Off: Checked-out
Red on: Checked-in
[Light Pattern Example: Checked-in Mode]
Room1230
DSS button
Room1231
Room1232
Room1233
Room1234
Rooms 1230 and 1234
are currently in
checked-in status.
Check-in button
Check-out button
Cleaned-up button
c. The lights of other buttons may not show their normal display.
d. The hotel
operator’s extension is considered to be busy. Callers to that extension will hear
a busy tone.
To check in a guest
Press Check-in. Dial extension number and then press
"ENTER", or press desired DSS.
OR
extension no.
(DSS)
While on-hook
ENTER
Press "YES". Press "EXIT"
or Check-in to finish.
EXIT
OR
(Check-in)
(Check-in)
6-Line Display PT
Room: 1234
Confirm check in?
NO YES
Enter Room Number
EXIT ENTER
To continue
Document Version 2008-10 Operating Manual 113
1.3.59 Room Status Control